Baumatic BDF665W - Manual (Page 24)

24
o
If you open the door whilst the machine is on a wash cycle, then
you should open the door slightly.
o
The spray arms will stop turning after a few seconds. You can
then open the door fully.
o
When you close the dishwasher door, after approximately 10
seconds the wash program will continue.
Changing the wash program
o
Press and hold down the program selection button of the wash
program that was in progress for 3 seconds, to cancel the wash
program.
o
Press another program selection button to choose the correct
wash program.
o
After a few seconds, you will hear the appliance continue with
the new wash program that you have selected.
o
IMPORTANT: You should only change a wash program if the
detergent has not been released into the machine; otherwise you
may get poor wash results.
At the end of a wash program
o
At the end of the wash program, an audible signal will sound for
8 seconds.
o
Use the ON/OFF button to switch the dishwasher off.
o
IMPORTANT: You should leave the appliance for 15 minutes
BEFORE opening the door. This will allow the steam generated
from the final rinse(s) to dry the dishes.
o
Carefully open the door of the appliance and leave it ajar for a
few minutes and allow any remaining steam to disperse.
o
WARNING: Hot steam may escape when the door is first
opened, so care should be taken.
o
Unload the dishwasher; you should take care in case any of the
items are still warm.
o
IMPORTANT: If you leave the door of the dishwasher shut and
do not unload the dishwasher for a prolonged period of time,
then you may get water droplets reforming on the washload.