Beisler 100-54 - Manual (Page 67)

3-13
2.1 Folder height
Move the machine to the neutral position and select
outputs 15 and 24 in the control.
The distance (A) between sliding plate and folder sole
must be set in accordance with the sewing material used.
The standard setting is 2 mm.
If the folder is set too low, the material will be blocked. If the
folder is set too high, the folding slides may fail to fold the
sewing material.
To change the setting, loosen the lock nut (1), rotate
the stop screw (2) clockwise or counter-clockwise, then
tighten the lock nut (1).
After the folding height has been changed, the position of
the initiator (4) at the swivel plate should be checked (see
Section 2.2).
2.2 Initiator at the swivel plate
As the folder is lowered completely, this initiator will be
switched to initiate the closing of the folding slides (if this
function is enabled in the program). If the initiator is not set
properly, the folding slides are activated too soon or not
at all.
To set the initiator, loosen the black retaining nut (3),
shift the initiator as required, then tighten the retaining
nut.
2.3 F
older height parallel to sliding plate
Rotate both stop screws (4) so that the folder is oriented parallel
to the sliding plate. While doing this, loosen the clamp
screws, push the folder up and tighten the screws.
2 Adjustments at the insertion station
2.4 Folder parallel to main clamp
<Power off> <Pressure off>
Loosen the two Allen screws (1) to the right and to the left
of the thumb screw and align the switch parallel to the main
clamp.
In this position, tighten the Allen screws.