BUG-O Systems CWP-11 - Manual (Page 14)

14
PROGRAMMING
FUNCTION KEYS
All programming is done using the PENDANT CONTROL. Use the following Alpha Keys for
programming:
A: To enter dimensions.
B: To enter the time delay for puddle build-up.
C: To change Program Number in memory (numbers 0 – 99).
D: To display the dimensions of the weld.
E: To enter the number of passes (1 – 99).
Three other useful key functions are:
Shift 9: Set units, english (inch) or metric (meters)
Shift 8: Test drives & encoders
Shift E: Version number (have this information ready when calling for service)
SAVING PROGRAMS
The machine has 100 storage areas or welds, numbered 0 to 99 in memory. Push the “C”
button on the pendant keypad to change (or set) the program number and enter the desired
number. Program data is retained until reprogrammed. At any time, one of these numbers is
selected, it will stay selected even when power is shut off and turned back on, it will not change
until the program number is changed by the operator. The time delay setting is not saved as part
of a program.
DATA ENTRY
When entering data with the pendant keypad, multiply inches, degrees, or seconds by 100 and
enter the number without a decimal point. For metric dimensions, multiply mm X 10 or cm X
100.
Example: 350 for 3.5 inches,
800 for 80 mm, on metric machines
Press “ENTER” on the keypad after the number is entered.
DATA REQUIRED
1. Small diameter (nozzle size)
2. Large diameter (pipe it fits on)
3. Offset distance between centerlines.
When entering data, use the diameter of the cylinder along whose intersection the cut has been
made. Usually this will be the inside diameter of the nozzle or the outside diameter of the pipe it
fits on. This will also allow for any bevel, if necessary. If no offset, enter “0” or just press “Enter”.
NOTE: If the STOP / RESUME button is pressed, the machine will be in pause mode, and can-
not be programmed. Press the RESET button to get back to the ready mode for programming.
ON-CENTER
NOZZLE
OFFSET
NOZZLE