BUG-O Systems DC IV v.2 - Manual (Page 14)

14
Parts List
ITEM PART NO. DESCRIPTION
1 AFR-1015 Spacer Washer
2 AFR-2001 Rack Adjusting Tool
3 AFR-3002 Splice Plate
4 AFR-3006 Rack
5 AFR-3009 Extrusion, Punched
6 FAS-0855 Flt Hd Sit Scr 1/4-20 x 1/2
7 FAS-0955 Flt Hd Soc Screw 1/4-20 x 1/2
8 FAS-1446-HW S.T. Slotted Hex w/ washer 10-32 x 5/8
9 WAS-0230 #10 Washer
FLEX RAIL
CAUTION: Bending beyond the recommended 15'-0" (5.0 m) radius may put
a permanent bend in the rail and break off some of the rack screws.
NOTE: Use at least four attachments (magnets or vacuum cups) on
each FLEX RAIL.
AFR-3000 FLEX RAIL replaces the old AFR-1000, 1010, 1020 and the later
AFR-2000 rails. All the rack-mounting holes on the AFR-3000 Semi-Flex Rail
are slotted so that the rack can slide along the rail. The length of the slots has
been increased so that the rails can now be leapfrogged around a complete
circle. The tension of the screws holding the rack on the rail is adjusted so that
the rack can be moved along the rail with the AFR-2001 Rack-Adjusting Tool.
FLEX RAIL can be bent inside or
outside to a minimum radius of 15'
(5.0 m) or 30' (10.0 m) diameter without
permanent deformation.
8'
(2.37 m)
MIN. RADIUS
15' (5 m)
AFR-3000 / FLEX RAIL
A 2.75" (70 mm)
B 4.0" (1 02 mm)
C .33" (8.5 mm)
D .500" (12.7 mm)
8'
(2.37 m)
A
B
4
6
1
7
3
9
8
2
5