BUG-O Systems Stiffener Welder - Manual (Page 7)

7
The carriage has four Adjustable Guide Wheels (K) for quick adjustment or
change. Use the Adjustable Clamp Levers (M) to set the guide wheels so
that the workpiece (STIFFENER) is centered under the carriage.
Two Fits-All Clamps (L) are mounted on a bar at the front of the carriage to
clamp the power and cables for each wire feeder, and act as a strain reliever.
DO NOT PUT THE WIRE FEED CABLE (w/ TORCH) IN THESE CLAMPS!
At the front of the carriage, three holes
(1), (2), and (3) are located on both the
left and right hand sides of the deck plate.
Holes (1) and (2), or (2) and (3) are used
to bolt the Clamp Block Assembly (N)
that holds the Comer Follower (P).
By selecting the proper holes, it is pos-
sible to mount the guns opposite each
other or staggered by 2-1/2" (64 mm).
DIRECTION OF TRAVEL
WHEN WELDING
> >
1 3 2
L
L
1 2 3
WORKPIECE
M M
K
M M
CARRIAGE
REAR
1
2
3
CLAMP BLOCK
ASSEMBLY (N)
CORNER
FOLLOWER (P)