Burst Electronics MCG-3 User Manual
Page 13
12
MCG-3 Color Micro Character Generator
cable to the DB9 to RJ11 adapter, and connect the other end to the
RJ11 connecter on the MCG-3 marked
HOST
. (It is assumed that the
MCG-3 is connected to a video source and a monitor, and that the
MCG-3 is turned on.)
Next, run your communications program. You will need to set up the
program for the following:
Set the COM port to either C
C
C
C
CO
O
O
O
OM1:
M1:
M1:
M1:
M1: or C
C
C
C
CO
O
O
O
OM2:
M2:
M2:
M2:
M2:
(Depending on what you chose earlier.)
Baud rate: 9600 baud
(Unless you changed it in the Utility Menu
Utility Menu
Utility Menu
Utility Menu
Utility Menu)
Stop bits: 1
Data bits: 8
Parity: None
Echo: Off (or Set Duplex to Full)
Note that other combinations may not work reliably or may not work at
all, so please double check your connections and communications
program setup. Also confirm that the MCG-3 Device I
Device I
Device I
Device I
Device ID
D
D
D
D code is set to
0
0
0
0
01
1
1
1
1, in the utility menu.
If you did everything correctly, then when you type on your computer
keyboard the REMOTE light should flash.