Burst Electronics MCG-3 - Manual (Page 66)

65 MCG-3 Color Micro Character Generator
ERROR MESSAGES:
The RS232 remote control ROM software has five error messages as
follows:
#1 Err #1 Err #1 Err #1 Err #1 Error - Unknown command or - Unknown command or - Unknown command or - Unknown command or - Unknown command.....
The MCG-3 did not understand the command you sent it. The
command is probably misspelled. Look up the command in the
Command Reference Section.
#2 Err #2 Err #2 Err #2 Err #2 Error - Bad par or - Bad par or - Bad par or - Bad par or - Bad parameter ameter ameter ameter ameter.....
One or more of the parameters in a command sent to the MCG-3 is
either too large, or too small, or of the wrong type (letters were sent
when the command wanted numbers or vice versa). Also this error can
occur if not enough or too many parameters are sent. Look up the
command in the Command Reference Section.
#3 Err #3 Err #3 Err #3 Err #3 Error - R or - R or - R or - R or - Real time clock not installed eal time clock not installed eal time clock not installed eal time clock not installed eal time clock not installed.....
This error occurs when a RTC command is issued but the RTC option
is not installed.
#4 Err #4 Err #4 Err #4 Err #4 Error - Command una or - Command una or - Command una or - Command una or - Command unavailable. vailable. vailable. vailable. vailable.
This is an error that you are not likely to see. It is only produced with
custom ROM software and for special purposes at the factory.
#5 Err #5 Err #5 Err #5 Err #5 Error - Comma missing or misplaced or - Comma missing or misplaced or - Comma missing or misplaced or - Comma missing or misplaced or - Comma missing or misplaced.....
This error may be produced by not having enough commas in a
command sequence. In issuing a command there must be a comma
after the command to separate the command from its parameter(s).