Cadac C-Type - Manual (Page 22)

2-8 Input channel module 7911
C-Type Revision C2005-2
514168 ,QVHUW#3UH23RVW#(4
Press this switch to select Insert point PRE or POST Equalizer.
514169 ,QVHUW#,Q22XW
All input channels have a Send and Return break-jack facility. This is to allow the
channel signal to be sent out to, and returned from an external processing unit. A
relay is used to switch the insert function “in” and “out”. The relay is controlled by the
insert (INS) switch.
51416: 6ROR
This button places the post-fader signal, panned 2.0, 4.0 or 5.1 via the controls in the
MONITOR module, to the monitor speakers. All other channels are muted.
51416; 0HWHU#'02
Pressing this button selects the meter to read the level of the Direct Output in place
of the pre-fader signal.
51416< 3)/
Pressing this button places the pre-fader signal into the MONITOR module where it
can be checked on the monitor speakers, small L/S or headphones.
514173 087(
Pressing this button mutes all post fader signals leaving the input channel.
514174 /('#PHWHU
This 20-segment LED meter indicates the channel level immediately pre-fader, or the
direct output level.
514175 )DGHU
A 100mm fader controlling the signal level to the stereo busses, Groups and all post
fader sends.