Campomatic CT1190 - Manual (Page 12)

11
1) Press key, then using
▲ or ▼ key to select HS DEFAULT item.
2) Press key to confirm.
3) The user will be prompted to enter the PIN CODE, the display shows PIN?, then press numerical
keys to input code.
4) If the PIN code is validated all base settings will be returned to the factory default.
Handset Menu function 5: REGISTRATION
This function allows the user to register the handset to a specified base.
Before registering a handset to the base, the base should first be put into subscription mode, by pressing
the “ ” key till the base charge/In use LED flashing.
1) Press key, then using ▲ or ▼ key to select REGISTERATION item.
2) Press key to enter.
3) Press ▲ or ▼ key to select BASE names.
4) Press key to select base as required, the display shows SEARCHING.
 If the base is found and the handset successfully registered, the PIN code screen will be
displayed, then enter the pin code(defaulted as 0000, if input wrong number, press R/CLR to
delete)
 If the base is not found, the handset will return to the previous registration state.
 If the PIN code entered is invalid, an error tone is sounded, and the Handset will return to the
previous registration state.
 If have several handsets, repeat the above steps to register another handset, and the
successfully registered handset will displays HS2 or HS3 on the LCD according to the
registration sequence.
NOTE: Press key to page the handset when difficult to look for.
OPERATION
Speakerphone operation & volume control
Press key once to obtain a dial tone, dial your number, when you hear the called party answers the
phone. You can begin your conversation without picking up the handset, you can also answer an incoming
call by pressing the key once.
During the speakerphone operation, the user can adjust the speaker volume level by pressing the
▲ or ▼
key .Total 6 levels for selection.
Mute the mouthpiece
During a call, press MUTE key once to mute the mouthpiece and MUTE will show on LCD. Press MUTE key
again to get back to the call and the MUTE will disappear.
Caller ID – type I & II
 TYPE I
After you have applied the caller ID service, you can see the caller party phone number during an incoming
ring.
 TYPE II