Campomatic CT1190 - Manual (Page 13)

12
During the conversation, the phone number of the incoming call of the third party can be seen in the unit.
This function can be worked when the user applied the Telecom service.
Auto timer
The timer will start automatically after 6s of the telephone line is engaged.
Flash (R)
Press R/CLR key to reset the line with our leaving the handset.
Pause
Press RD/P key will insert a time delay of 3.6 seconds in a dialing sequence.
Pre-dialing
The unit has pre-dialing function, when you may enter and edit the number before dial it out.
The following procedure describes how to use this function:
1. In idle mode, enter the number you want to dial. During entering, you can press R/CLR key to correct
the number.
2. Press or key once, the unit will dial out the number show on the LCD.
Redial function
1. Press key or key,
2. Press RD/P key, the last dialed number will be dialed again
NOTE: the maximum length of name & number are 12 characters & 20 digits respectively.
Name matching
If you have edit the incoming message with different name, next time with the same incoming number will
display the modify name.
Review /delete /call back incoming numbers
 Review
In on hook state, press
▲ key once and then use ▲ or ▼ key to scroll and review the incoming numbers
 Delete
When the desired number displayed on LCD, press R/CLR key one time to delete it .
 Call back
When the desired number is shown, press or key to dial out the number.
Review /delete /call back outgoing numbers
 Review
In on hook state, press ▼ key once and then use ▲ or ▼ key to scroll and review the incoming numbers
 Delete
When the desired number displayed on LCD , press R/CLR key one time to delete it .
 Call back
When the desired number is shown, press or key to dial out the number.
Edit & copy incoming messages to phonebook
The user can store the incoming number to the phone book based on the following procedures:
1) Press ▲ key once, LCD will show the last received record.