Caple RFF60 - Manual (Page 14)

12
Care and Maintenance
1. Firstly, take the handle set bolts out from the refrigerator, use a
cross head screwdriver to set the bolt on the door. Fix it tight with all the
screw thread twisted through the hole, as shown in the diagram.
2.
After the first step is completed, take the Cold storage door handle
out from the box, place it as per the direction shown in the diagram (Note:
i.e. the direction which both screw holes on the handle are close to the
edge), and hang the handle above the set bolt;
3.
Use the small hexagon spanner supplied in the box to set the handle
fixing socket head cap screws into both the small screwed holes on the
handle. After they are screwed down, gently shake the handle, so as to
confirm that the handle is well erected.
Handle Installation Sketch Map
Simple Fault Analysis and Elimination
Please read this following contents before maintenance
Problem Possible Causes
The fridge will
not turn on
Not cooling
sufficiently
Loud noises
Food in the fridge
is freezing
Odour in the fridge
Has it been connected to a power supply? Has the
plug been inserted firmly and switched on?
Is the voltage too low
Is the temperature adjusted to high
Is there too much food in the fridge
Is there any hot food in the fridge
Is the being opened and closed to often
Has the door been closed correctly
Is there any heat source around the fridge
Has it been installed on flat ground, and the the feet
have been adjusted correctly
Are the fridge accessories positioned correctly.
Is the fridge set to 'speed cooling' mode
Is there food with a high moisture content stored.
Food with strong smells should be well covered
Is there any food which has gone off
Clean the inside of the fridge