Caple TDF200 - Manual (Page 11)

• FILLING THE STEAM TANK
21 20
EN EN 6 / REGULAR MAINTENANCE
• CLEANING THE STEAM TANK
Advice :
If you have not used the Steam pro-
gram for several months, we recommend
that you replace the water contained in the
tank.
To clean the inside of the tank, you should
completely remove it from its housing.The
tank lock is located inside the door
(Fig. 11).
To clean the tank, proceed as follows :
— Press on the tank to open it.
— Use the side of a coin to unlock the tank
(Fig.
12).
— Remove it from its housing by pulling it from
bottom to top
(Fig. 13).
— Simultaneously push on both sides of the
upper part of the tank and unclip the cover
(Fig. 14).
— Clean the inside of the tank, as well as the
filter, which can be immersed in water
(Fig.
15).
— Clip the cover back onto the tank.
— Return the tank to its housing, seating the
lower part first.
— Press on the upper part of the tank to re-
seat it in its housing.
Fig. 11
Fig. 14
Fig. 13
Fig. 12
Fig. 15
6 / REGULAR MAINTENANCE
Important :
We remind you that the tank must be fil-
led before the "Steam" program is used for
the first time.
Important :
Only fill the Steam tank with distilled
water or fully demineralised water. Do not
use tap water or water containing any additi-
ves. The water from the recovery tank can
also be used provided that it has been filte-
red using the filter provided for this purpose
on the steam tank inlet.
To fill the tank, proceed as follows :
— Press on the upper part of the tank to free it
from its housing
(Fig. 06).
— Fill the tank (Fig. 07).
— Press on the upper part of the tank to re-
seat it in its housing.
You can also use the water from the recovery
tank :
— Remove the water recovery tank
(see fig. 20
on the next page).
— Extract the channelling tube from the water
recovery tank
(Fig. 08).
— Fill the tank (Fig. 09).
— Press on the upper part of the tank to re-
seat it in its housing.
Important :
If you use water from the recovery
tank, regularly clean the tank filter by pulling
pills away with your fingers (Fig. 10).
Fig. 06
Fig. 07
Fig. 10
The 1.2 litre steam tank contains enough water to last approximately three cycles.
It is equipped with a filter that recovers the impurities found in the water. Properly filtered water is
necessary for smooth functioning of the steam generator.
Fig. 08
Fig. 09