Caple TDF200 - Manual (Page 5)

• COMBINED WASHER/DRYER INSTALLATION
• BUILT-IN INSTALLATION
• LEVELLING
• THE APPLIANCE’S SURROUNDINGS
9 8
EN EN 3 / INSTALLING YOUR TUMBLE DRYER
• BEFORE USING THE STEAM PROGRAM FOR THE FIRST TIME
Important :
The Steam tank is empty when your appliance is delivered. Before using the Steam pro-
gram for the first time, fill the tank with demineralised water or with water from the recovery tank
(see how to proceed in the "EVERYDAY MAINTENANCE" chapter).
The steam tank is empty when your appliance is delivered.
Important :
If you are fitting the appliance underneath a worktop, you must either keep the original
laminated top, or replace it with a slimmer version using a kit available for this purpose from your
dealer. For safety reasons, the appliance must never be operated without a top.
An adaptation kit is available from your dealer. This is used to mount your tumble dryer above your
washing machine.
Important :
Check with your dealer that the kit is compatible with your washing machine. For safety rea-
sons, fitting must be performed by a qualified professional.
3 / INSTALLING YOUR TUMBLE DRYER
Fig. 04
Fig. 03
Important :
We strongly advise against :
— Installing your appliance on a carpeted floor.
If you cannot avoid this, take all possible mea-
sures not to obstruct the circulation of air at
its base.
— Installing your dryer in a location where it
can be subject to being splashed with water.
— Installing your dryer in a small closed room
(if this is the case, open the door or the win-
dow during drying).
— Installing your dryer in a poorly ventilated
room. The temperature in the room must
remain below 30°C during drying.
1 cm mini
Advice :
Your tumble dryer releases heat. If you place it next to another appliance or a unit, we
advise you always to leave a space in-between for air circulation (Fig. 03).
Important :
Use a level to check that the appliance
is horizontal :
Your dryer is fitted with 4 adjustable feet
(Fig.04). To adjust the stability and levelness :
— Tip it slightly backwards.
— Screw one or more of the feet in or out using
a spanner or a screwdriver to adjust their
height to suit the shape of the floor
(Fig.04).
— Set your dryer back on its feet and check
that it is stable.
0.4 inches minimum