Caple TDF200 - Manual (Page 15)

29
EN
28
EN 8 / TROUBLESHOOTING
Fault : Check whether :
The items are unevenly dried : - The types of laundry in the load are too different (e.g.
sheets together with jeans)
- The laundry has been laid correctly ‘unfolded’ in the
dryer
- The drum is not overloaded.
The synthetic items are loaded with
static electricity : - The laundry has been dried too much
- You have used softener during washing. By using this
product, you can reduce most of the problems with
static electricity.
The “Tank Full” indicator light is lit : - The condenser tank is full : once you have emptied it,
re-insert it correctly, pushing it completely into its
housing
The “Tank Full” indicator light illumi-
nates although the tank is empty : - The container has been properly inserted : push it in
completely.
- The condenser is tightly locked on the two sides.
The "Empty tank" indicator is lit up : - The steam tank is empty : after emptying it, put it
back into position, pressing it firmly into the housing.
The program picks up where it had stopped.
The laundry will be slightly damp
after a steam cycle : - You have used a steam programme : in this case, it is
completely normal, and it will make ironing easier.
8 / TROUBLESHOOTING
Fault : Check whether :
The dryer does not start : - The plug is in the socket
- The On/Off button is pressed in
- The door is properly closed
- The condenser is correctly locked in place.
The drying times are too long : - The filter in the drum is clogged with lint.
- The condenser is not clogged.
- The filter and condenser housings are not clogged or
soiled.
- The laundry has been spun enough beforehand
(500rpm minimum, but spinning at 850rpm provides
shorter drying times).
- The room temperature is not too high, particularly if
the room is small : if necessary, open the door or win-
dow.
- The air inlets and outlets are unobstructed enough to
ensure correct air circulation.
- The selected drying program does indeed correspond
to the type of laundry in the drum.
The laundry is too damp : - The filter in the drum is clogged with lint
- The type of drying has been selected correctly (too
low) : switch to the next program up or increase the
drying time.
- The condenser is not blocked by lint.
The laundry is too dry, too creased : - The selected drying program does indeed correspond
to the type of laundry in the drum.
Advice :
Some incidents may arise when you are using your dryer. Here are the points you should
check, before contacting the After sales service.
8 / TROUBLESHOOTING