Caple C2214 - Manual (Page 10)

10
-replacing the electrical socket when it is not compatible with the appliance plug.
Caple service must be contacted in the following cases:
-If in doubt about the soundness of the appliance after removing it from its packaging;
-if the power supply cable has been damaged or needs to be replaced;
-if the appliance breaks down or functions poorly.
You must do as following:
-only use the appliance to cook food and nothing else;
-check the soundness of the appliance after it has been unpacked.
-disconnect the appliance from the electrical mains if it is not functioning properly and before
cleaning or performing maintenance.
-when left unused, unplug the appliance from the electricity mains;
-use oven gloves to place cookware in the oven or when removing it.
-always grip the oven door handle in the centre.
-make sure the knobs B and C are in the “●” position when the appliance is not in use.
-disconnect the oven from the mains when you decide not to use the appliance for long periods of
time.
-the manufacturer may not be held responsible for any damage due to: incorrect installation,
improper, incorrect or irrational use.
-If the power cord is damaged, it must be replaced by the manufacturer or a qualified service
engineer to avoid any risks to safety.
-The appliance is for indoor use only.
Installation
The appliance must be installed only by a qualified person in compliance with the instructions
provided. The manufacturer declines all responsibility for improper installation which may be harmful
or may damage property.
Important: the power supply to the appliance must be cut off before any adjustments or
maintenance work carried out.
Installation of built-in ovens
In order to ensure that the built-in appliance functions properly, the cabinet containing it must be
appropriate. The figure below gives the dimensions of the cut-out for installation under the counter or
in a wall cabinet unit.