Caple C2214 - Manual (Page 5)

5
Note: do not turn off the power while the oven is cooling.
How to look after your oven
Before cleaning your oven or performing maintenance, disconnect it from the power supply. To
extend the life of your oven, it must be cleaned frequently:
1 Do not use steam equipment to clean the appliance.
2 The inside of the oven and stainless steel parts should be cleaned after every use, when the oven
is cool, with a soft damp cloth with mild detergent. The detergent should be wiped away and the
interior dried thoroughly. Avoid using abrasive detergents (for example cleaning powders, etc...)
and abrasive sponges or acids (such as limescale-remover, etc…) as these could damage the
enamel and stainless steel. If the grease spots and dirt are particularly tough to remove, use a
special product for oven cleaning, following the instructions provided on the packet.
3 If you use your oven for an extended period of time, condensation may form. Dry it using a soft
cloth.
4 There is a rubber seal surrounding the oven opening which guarantees its perfect functioning.
Check the condition of this seal on a regular basis. If necessary, clean it and avoid using abrasive
products or objects to do so. Should it become damaged, please contact Caple service. We
recommend you avoid using the oven until it has been repaired.
5 Never line the oven bottom with aluminum foil, as the accumulation of heat could compromise
the cooking functionality and even damage the enamel.
6 Clean the glass door using non-abrasive products or sponges and dry it with a soft cloth.
7 Do not use harsh abrasive cleaners or sharp metal scrapers to clean the oven door glass as they
can scratch the surface, and could cause the glass to break.
How to remove the oven door
For a more thorough clean, you can remove the oven door, proceed as follows:
Open the door fully.
Lift up and turn the small levers situated on the two hinges;
Grip the door on the two external sides; close it slowly but not completely;
Pull the door towards you, pulling it out of its seat.
The door is replaced by reversing this process.