Cata CM 760 AS - Manual (Page 43)

4) At the completion of the set duration, the timer will stop
the oven and give an audible warning. Also, the symbol
”A” will begin to fl ash on the screen. After bringing the cooking
function and oven temperature knob to “0” position. Pressing
any button less than 3 seconds, it will stop the audible warning.
Pressing ” “ for more than 3 seconds set the oven to Manual
mode again to use the oven.
Full-automatic programming:
This function is used to cook after a certain period of time, with
a certain duration. The food to be cooked is put into the oven.
The oven is adjusted to the desired cooking function. The oven
temperature is adjusted to the desired degree depending on
the food to be cooked.
First: Press ”
“ button until you see “Dur“ on the timer
screen. Use “+” “-“ button to adjust cooking period for the food
you wish to cook. Press ”
“ button to confi rm, the day‘s time
will appear on the screen and the symbols “A“ will begin to
continuously light on the screen.
Second: keep pressing on ”
“ button until you see “End” on
the timer screen. When you see “End” on the timer screen,
Use “+” “-“ button to adjust fi nishing time, Press ”
“ button
to confi rm, the day‘s time will appear on the screen and the
symbol “A” will begin to continuously light on the screen. The
symbol ”
“ disappears until the time cooking starts.
You can set a time which can be up 23.59 hours after the time
obtained by adding the cooking period to the day’s time.
The oven will start operating at the time calculated by
deducting the cooking period from the set fi nishing time, and
will stop at the set fi nishing time. The timer will give an audible
warning and the symbol “A” will begin to fl ash. After bringing
the cooking function and oven temperature any button less
than 3 seconds, it will stop the audible warning.
Pressing ”
“ for more than 3 seconds set the oven to Manual
mode again to use the oven.
Please note:Once setting full-automatic mode, all the time
can not be changed. Change time means cancle automatice
progamme and enter into corresponding mode. If you need to
reset automatic mode, need to stop setting the current mode,
to set the automatice mode according to the above steps again.
Spectifi cation
1) Long press on ”+” or “-” for more than 3 seconds, the date
will progressively and rapidly increase or decrease in the
rate of 5 seconds.
2) When setting each of the time function, if there is none
operation for 5 minutes then it will return to manual mode.
3) When setting each of the time function, pressing on ” “ for more
than 3 seconds can cancel current setting and enter manual mode.
4) During time function setting, pressing on “+”and ” “ for
more than 3 seconds, a beep sounds it can cancle the curent
time function setting and enter standby mode.
5) We suggest that you run the oven elements for 15 minutes
at 200 degrees to burn off any residuce from their surfaces.