Cata ME 605 TC - Manual (Page 41)

REPLACEMENT OF THE NETWORK POWER SUPPLY LEAD
If it is necessary to replace the network power supply lead,
proceed as follows:
1. Disconnect the appliance from the power supply, unscrews
the fastening screws and remove the rear panel.
2. Unscrew the fastening screws and those of the terminals to
free the existing lead.
3. Assemble the replacement lead which must comply with the
information listed in the Specifications, ensuring the correct
connection of the colour codes and that all the screws are
correctly tightened.
MAINTENANCE
Before carrying out maintenance, disconnect the appliance
from the power supply.
During the guarantee period, if necessary all services should
be commissioned to the Manufacturer’s Technical Assistance
Service Department. Bear in mind that intervention or repair
by unauthorised personnel will invalidate this guarantee.
REPLACEMENT OF THE OVEN LIGHTBULB
(Not covered by the appliance guarantee.)
The oven has a light with the following characteristics: 15 W or
25 W, 300 ºC and type E-14
WARNING: Disconnect the appliance from the electricity sup-
ply, remove the oven door (as described above), as well as the
oven shelves.
Remove the glass cover that protects the light bulb by turning it
anti-clockwise. Fig. 9 (A)
Unscrew the old light bulb and dispose of it safely and ecolog-
ically, change it for one as specified in the Specifications and
replace the cover.
NOTE – The glass cover may be tight and, therefore, may need
a grip to release it.
CARE AND REPLACEMENT OF THE CATALYTIC COVERING
(When assembled, the covering is not covered by the appli-
ance guarantee).
In order to keep the covering “always clean” efficiently, the
oven must be heated to a minimum of 200 ºC whenever there
are stubborn stains, so that they do not become permanent.
If the covering becomes black and shiny, they must be
replaced. Remove all the internal accessories to facilitate the
replacement of the covering.
The replacement covering may be bought directly from the
Manufacturer’s Replacement Part Department (see details
included in the cover). Indicate the reference numbers of the
product type described in the specifications plate and/or the
series number of the appliance on ordering.
SPECIFICATIONS
INTERIOR DIMENSIONS
Height: 340 mm
Width: 440 mm
Depth: 390 mm
Useful volume: 59 litres
ELECTRICAL INFORMATION
Nominal voltage:
220 V - 240 V ~ 50 Hz
Power connection: 13A (automatic bipolar switch with protect-
ed socket, with 3mm separation between contacts)
POWER ABSORPTION
Base Resistance: 1,30 kW
Roof Resistance: 0,90 kW
Fan Resistance: 2,30 kW
Grill Resistance: 1,35 kW
Network power cable:
3 x 1.5 mm 2 type H07RN-F <HAR>
Oven light bulb:
15 W - 25 W / 300 ºC screw type E-14
The Manufacturer declines all liability for damage caused to
persons and objects due to incorrect or improper installation
of the appliance.
The Manufacturer reserves the right to make any modification
it believes necessary and useful to the products, without prior
warning.