Ready Remote 24927 - Manual (Page 11)

8 © 2 0 0 6 D i r e c t e d E l e c t r o n i c s
H1 Harness - 6 pin connector
___
___
___
___
___
___
Pin # Color Note
H1/1 Yellow Selectable positive or negative parking light output
H1/2 Brown/White Use this wire if the vehicle is equipped with a
factory alarm. Connect to disarm wire listed on your
sheet.
H1/3 Violet Connect this wire to supplied hood pin switch
H1/4 Orange Connect this to wire in vehicle that shows 12 volts
when brake is pressed
H1/5 White/Black Provides a ground during remote start. This wire is
normally connected to a bypass module if your
vehicle needs one.
H1/6 Red/White This wire will start the vehicle when it sees two
negative pulses. Only used when incorporating into
existing alarm or for testing purposes.
RED/WHITE (-) remote start activation input
WHITE/BLACK (-) 400mA status output
ORANGE (+) brake switch shutdown input
VIOLET (-) hood pin shutdown input
BROWN/WHITE (-) factory disarm output
YELLOW (+/-) parking light output H H1 1//1 1
H H1 1//2 2
H H1 1//3 3
H H1 1//4 4
H H1 1//5 5
H H1 1//6 6