Ready Remote 24927 - Manual (Page 50)

47 © 2 0 0 6 D i r e c t e d E l e c t r o n i c s
System Diagnostics
Alarm diagnostics
When arming or disarming the alarm, this system will alert you of
alarm triggers or active inputs by changing the Horn/Siren and
light flash output. It will then indicate the active input by
flashing the LED.
Arming diagnostics:
When arming, if an alarm input is active (door or hood open) the
Horn/Siren output and Parking Lights will pulse three times
instead of one as an alert.
The LED will then flash/pause and then repeat 5 times to indicate
the active input (See alarm input chart)
The active input will be bypassed until it has been inactive for
more than 5 seconds but all other alarm inputs will be monitored
normally to assure the security of the vehicle
Disarming diagnostics:
When disarming, if the alarm was fully triggered in your absence,
the Horn/Siren output and Parking Lights will pulse four times
instead of two as an alert.
The LED will then flash/pause and then repeat 5 times to indicate
the input that caused the trigger (See alarm input chart).
note! If the alarm was triggered more than once, the
diagnostics will only report the last input that fully
triggered the alarm. Sensor War-away triggers are not
reported in diagnostics.