Ready Remote 24927 - Manual (Page 12)

9 © 2 0 0 6 D i r e c t e d E l e c t r o n i c s
H2 Harness - 8 pin connector
___
___
___
___
___
___
___
___
Pin # Color Note
H2/1 Green Use this wire if the vehicle fails to start correctly in
voltage mode
H2/2 Blue Negative output to horn or siren circuit. If your horn is
positive, use a relay.
H2/3 Red/Black Used on diesel engines only. Connects to wait-to-start
wire
H2/4 Yellow/Green Ignition output. Connect this wire to the ignition input
of an aftermarket alarm system.
H2/5 Green/White Trunk release wire. Connect this wire to trunk release
wire listed on your vehicle specific printout.
H2/6 Brown Retained accessory shutdown or factory rearm output.
Connect this wire to factory arm wire if equiped or to
door trigger wire if your vehicle’s accessories stay on
after remote start finishes cycle.
H2/7 Yellow/Brown Headlight output. Connect this wire to headlight wire
in car. If headlights are positive, a relay is required.
H2/8 Gray/Black Door trigger input. This wire connects to the door trig-
ger wire in your car to set off alarm when system is
armed and door is opened.
GRAY/BLACK (-) door trigger input
YELLOW/BROWN (-) 400mA headlight output
BROWN (-) 400mA RAP, Domelight, Starter Kill
GREEN/WHITE (-) 400mA trunk release output
YELLOW/GREEN (+) ignition output
RED/BLACK (-) wait-to-start input
BLUE (-) 400mA horn/siren output
GREEN Tachometer input
H H2 2//1 1
H H2 2//2 2
H H2 2//3 3
H H2 2//4 4
H H2 2//5 5
H H2 2//6 6
H H2 2//7 7
H H2 2//8 8