Coloronix 6″ RGB Pathway Light - Manual (Page 11)

Tro
If do
Electrical power is less than specific voltage.
DMX control device is disconnected or not operating.
the fixture is not responding to DMX, check if:
DMX addressing is wrong:
Check Control Panel and unit addressing.
gs may be on the controller:
witch settings on the controller.
DMX cables may be loose:
ble connectors.
ck if:
device in daisy chain is not terminated.
DMX cable is damaged.
n 25Hz.
there i
ables (see page 10).
DMX terminator is not installed as suggested.
output
Environment temperature may be in excess of 50C/122F.
urther Tr
ubleshooting Guide
es not light, check if:
Electrical power is not connected.
Electrical power is greater than specified voltage.
does not respond to DMX control signal, check if: If
DMX control device and RGBW are addressed differently.
DMX cable is damaged.
DMX device needs to be restarted.
LED fixture was not restarted after address change.
If
The wrong polarity settin
Check polarity s
Check ca
If DMX control operation flickers or is intermittent, che
RGBW Color Changing Pathway Light or final DMX
DMX control device is operating at less tha
If
s a loss of signal, check if:
Non-DMX cables are being used:
Use only DMX compatible c
Signals are bouncing:
If
is less than normal, check if:
Lens may be damaged or dirty.
DMX control or RGBW channels may be set at low level.
F oubleshooting
Should problems occur while using the product, unplug it at once and contact:
Coloronix, Inc.
Tech Support: (909) RGBW-555
[email protected]
Replacing a Failed Fixture
“H apping” a ot Sw laced, the steps are to:
1. Disconn e needing replacement.
4.
5.
6.
9. Make sure the replaced fixture and the entire system is in working order.
fixture is not allowed. If a fixture needs to be rep
ect the DMX input at the junction box of the fixtur
2. Disconnect DMX output.
3. Replace
fixture.
Reconnect AC negative.
Reconnect AC positive.
Reconnect DATA output.
7. Reconnect DATA input.
8. Reconnect
power.
Page 11—Coloronix RGBW Pathway Lighting Manual V1.0