2 (test:) bert, 3 (test:) comp – Comtech EF Data CDM-760 User Manual

Page 146

Advertising
background image

Front Panel Operation

Revision 2

CDM-760 Advanced High-Speed Trunking Modem

MN-CDM760

6–60

6.2.4.2 (TEST:) BERT

BER:No Sync Count:0.0E+00 Errs:0.0E+00

BERT:On Patt:2^23-1 Restart ErrIns ()

On the top line – Read-only BER (Bit Error Rate) information is provided as follows:

Parameter

Description

BER

This is the current Bit Error Rate of the demod. This BER figure is only available when BERT is ON.

When BERT is OFF, or if there is a mismatch in pattern selection, or if there is a substantial issue

with the link, this parameter displays “No Sync”.

Count

This is the total number of BERT Pattern bits received by the demodulator since BERT was enabled

or since the last Restart.

Errs

This is the total number of BERT Pattern bits received in error by the demodulator since BERT was

enabled or since the last Restart.

On the bottom line – Use the   arrow keys to select a function. Then:

Function

Instructions / Description

BERT

Press ENTER. Then, use the arrow keys to select ON or OFF. ON enables the BERT pattern

on the modem Tx and begins the search for the BERT pattern on the demodulator Rx.

Patt

Press ENTER. Then, use the arrow keys to select a BERT pattern that the modem can be set

to transmit and to search for on receive. Selections are 2047, 2^15-1, 2^23-1. The longest pattern,

2^23-1, is typically used in testing to ensure a solid data sync.

Restart

Press ENTER to reset all counters to 0.0E00.

ErrIns

Press ENTER to insert a single bit error that will be reported by the demodulator locked to the

BERT pattern.

6.2.4.3 (TEST:) Comp

K4 GZip Lossless Compression and Decompression in an optional feature that

requires installation of the Compression Card in the modem.

Bypass: Enable

()

Use the arrow keys to select Enable or Disable. Press ENTER. Note the following:

With Enable selected, K4 GZip compression is turned off (bypassed) while running a test (the

TEST MODE front panel LED Indicator is lit).

With Disable selected, this assumes normal modem operation with K4 GZip compression

operable (the TEST MODE front panel LED Indicator is not lit).

Advertising