Comtech EF Data CDM-760 - Manual (Page 371)

Appendix H Revision 2
CDM-760 Advanced High-Speed Trunking Modem MN-CDM760
H–5
A. Use the   arrow keys to navigate to Lat. Press ENTER to proceed. The cursor jumps to
the first alphanumeric character to edit:
CID:Lat: 0°25.43’N Long:110°58.28’W
State:On Telephone Message (  )
B. Use the arrow keys to change that character. Then, use the   arrow keys to
navigate to the next character to edit, and repeat. Press ENTER to save.
Latitude takes the form DD⁰MM.mm’C, where:
• DD = degrees (00 through 90)
• MM = whole minutes (00 through 60)
• mm = fractional minutes (0 through 99 (tenths or hundredths))
• C = compass cardinal point (N = North, S = South)
C. Use the   arrow keys to navigate to Long. Press ENTER to proceed. The cursor jumps to
the first alphanumeric character to edit:
CID:Lat:30°25.43’N Long: 10°58.28’W
State:On Telephone Message (  )
D. Use the arrow keys to change that character. Then, use the   arrow keys to
navigate to the next character to edit, and repeat. Press ENTER to save.
Longitude takes the form DDD⁰MM.mm’C, where:
• DDD = degrees (000 through 180)
• MM = whole minutes (00 through 60)
• mm = fractional minutes (0 through 99 (tenths or hundredths))
• C = compass cardinal point (E = East, W = West)
3) On the bottom line of the CID screen, enable transmission of CID information by the
modem:
A. Use the   arrow keys to navigate to State. Press ENTER to proceed. The cursor jumps to
the operational control:
CID:Lat:30°25.43’N Long:110°58.28’W
State: n Telephone Message (  )
B. Use the arrow keys to set the State as On or Off. The default is On. Press ENTER to
save.