Comtech EF Data TRP500 - Manual (Page 95)

TRP500-4450 C-Band Outdoor Amplifier REVISION 1
Appendix B MN-TRP500
B–29
Parameter Type Command
(Instruction
Code and
Qualifier) Arguments for
Command or
Response to
Query Description of Arguments
(Note that all arguments are ASCII numeric
codes between 48 and 57) Response to
Command
(Target to Controller) Query
(Instruction
Code and
Qualifier) Response to
Query
(Target to
Controller)
Retrieve Next 5
unread stored
Statistics N/A 75 bytes Query only.
Unit returns the oldest 5 Stored Statistics entries
which have not yet been read over the remote control.
Reply format: {CR}Sub-body{CR}Sub-body{CR}Sub-
body{CR}Sub-body{CR}Sub-body, where:
Sub-body=
ddmmyyhhmmssaaa.abbb.bccc.cdd.ddefghhh.hiii.i
ddmmyy = day/month/year
hhmmss = hour:minute:second
aaa.a = Operating Temperature (I.E. +40.0)
bbb.b = Amp Temperature (I.E. +40.0)
ccc.c = RF Power output
dd.dd = Attenuation Setting
e = Amp On/Off
f = Mute On/Off
g = Online/Offline Status
hhh.h = LNB Current (mA)
iii.i = BUC Tuning Voltage
If there are less than 5 entries to be retrieved, the
remaining positions are padded with zeros.
If there are no new entries, the response is RNS*.
RNS= RNS? RNS={CR}Sub-
body{CR}Sub-
body{CR}Sub-
body{CR}Sub-
body{CR}Sub-
body
(See description
for details of
arguments)
High Reverse
Power Threshold RPT= 5 bytes Command or Query.
This command allows the user to set the threshold for
the high reverse power alarm/fault. If the reverse
power is above the specified value, the alarm/fault will
be indicated. Setting this parameter to 00.00
effectively disables the threshold
Example: <1/RPT=00.00’cr’
>0001/RPT=’cr’’lf’
Default Value: 00.00
RPT =
RPT?
RPT *
RPT? RPT =xxx.x
(Same format as
command
arguments)
Serial Number N/A 9 bytes Query only.
Used to Query the unit’s 9 digit serial number in the
form of RSN=xxxxxxxxx, where: xxxxxxxxx is the
unit’s 9-digit serial number.
Example: <1/RSN?’cr’
>0001/RSN=072282040’cr’’lf’
RSN= RSN? RSN=xxxxxxxxx
(See description
for details of
arguments)