ConnectGear GR-104 - Manual (Page 19)

19
Maximum Idle Time
You can specify an idle time threshold (minutes) for the WAN
port. This means if no packets have been sent (no one using the
Internet) during this specified period, the router will automatically
disconnect the connection with your ISP. Note: Idle time “0”
means no time out, e.g. no time restriction (always On)
Auto-reconnect
If you check the Auto-reconnect function, then when the WAN
connection is disconnected the router will automatically re-
connect when there is a request by a user to access the Internet
Click <OK> when you have finished the configuration above. Congratulations! You have
completed the configuration for the PPPoE connection. You can start using the router now, if you
wish to use some of the advance features supported by this router see chapter 2, 3, 4.
1.4 PPTP
Select PPTP if your ISP requires the PPTP protocol to connect you to the Internet. Your ISP
should provide all the information required in this section.