Daktronics Sportsound Rack SSR-200 Operation Manual - Manual (Page 21)

Setup & Operation 15
3.4 Wireless Mic System Operation
Basic instructions are described below. For more information about wireless mic system
operation, refer to the Shure
® QLX-D ® Wireless System User Guide.
Note: For systems built prior to November 2014, refer to the Shure ® ULX ® Wireless
System User Guide for setup and operation instructions.
Wireless Receiver
The unit displays the following information (Figure 23):
a) Transmitter Battery Life
b) TV Channel
c) Frequency
d) Group Number
e) Channel Number
f) RF Signal Strength
g) Transmitted Audio Level
h) Gain Level
Single Receiver
1. Ensure all transmitters are powered off. Press the power button to turn on the
receiver if it is not already on.
2. Press menu until “scan” displays on the LCD.
3. Press enter to start frequency scan. When scan is complete, Group and Channel will
display on the LCD.
Network Receivers
1. Ensure all transmitters are powered off. Turn on all receivers and wait one minute to
allow time to connect to the network.
2. Press menu on one receiver until group number flashes.
3. Use the arrow buttons to select a group to scan.
4. Press enter, wait for channel, and then press enter again
5. Press menu until “network scan” displays on the LCD.
6. Press enter twice to deploy channels to other receivers.
Note: Perform a scan on all of the wireless units just minutes before the game! If a scan is
performed too far ahead of time, frequencies set up by the media later on may interfere with
previously configured wireless microphone settings.
Figure 23: Wireless Receiver LCD & Controls