Dataprobe iPIO-8 Operation Manual - Manual (Page 3)

iPIO-8
Page 3
Power supply
The iPIO is provided with a wall mounted power supply, item
1930075. This power supply is provided with four plug styles to
accommodate most locations. The plug for North America is pre
installed. To remove the plug, slide the tab located under the plug
and lift the plug out. For another location, attach the appropriate
plug to the power supply body. Insert the top of the plug in first,
then slide the tab and insert the bottom of the plug. If a suitable
plug style is not provided, use an adaptor power cord (not
provided) appropriate for your location.
Connect the power supply to the +5VDC connection on the iPIO.
An LED next to the connector indicates power on. The iPIO-8 requires a 1 minute boot-up process.
Power Supply 1930075
Input 100-240 VAC 50-60Hz
Output 5 VDC 2.6A
Network
Connect the network to the iPIO-8 with the Cat 5 cable, provided, or suitable replacement. The
Network connector on the iPIO-8 has two LED indicators. The orange LINK LED indicates a successful
connection to the network. The Green ACT LED blinks to display network activity.
LED Indicators
Pwr Power On indication
Rmt
Remote Communication Status indication
LED OFF No Remote Units Programmed
LED ON All Remotes Communicating Normally
LED Flash One or More Remotes with Communication Error
Input The iPIO-8 has eight LED indicators, displaying the status of the Inputs.
LED OFF Input Open
LED ON Input Closed
During power up sequence, LEDs will be off until boot complete, then flash once, then set to
their current status.
ELK-912-2 to iPIO-8 Connection
Power Supply 1930075 Supplied
Specifications – ELK-912-2
Operating Voltage : 12 VDC Nominal
Current Draw: 30 mA
Minimum Pull-in Voltage: 9VDC
Diode Protection Across Relay
Contact Rating:
7 Amps @ 30 VDC
10 Amps @ 125 VAC
Physical: 2.2” x 1.55” (56mm x 39mm)