Digi-Star GT400 - Manual (Page 14)

Weighing Errors
10 GT400 User’s Manual D3831 Rev B
WEIGHING ERRORS
Over-Capacity Limit (
OVRCAP
)
The display shows the message "OVRCAP" if the weight on the scale system
exceeds the capacity limit. The capacity value is entered in SETUP to warn of
overloading the scale system.
Over Range (
+RANGE
)
The display shows the message "+RANGE" if the weight on the scale system
exceeds the maximum weight measurable by the scale system. The over
range value is always the system’s maximum A/D counts multiplied by the
scaling factor. The actual weight at which over range occurs depends on the
calibration, zero, and display count size.
Under Range (
-RANGE
)
The display shows the message "-RANGE" if the weight on the scale system is
less than the minimum weight measurable by the scale system. The under
range value is always the system’s minimum A/D counts multiplied by the
scaling factor. The actual weight at which under range occurs will depend on
the; calibration, zero, and display count size.
Low Battery Indication (
LO BAT
)
If the supply voltage drops below the (10.5 Volts), the message
“
RECHARGE
BATTERY - TURNING OFF”
and
“
LO BAT
”
will periodically show on the display to
alert the operator of the low battery condition.
RUN SELF TEST
1. Press 3 seconds until the
LB symbol starts to blink.
Release.
2. Press to start the Self Test.
1