Digi-Star Cab Control 400 - Manual (Page 7)

Operators Manual
D3674 5
The Cab Control 400 is setup at the factory. There is one
selection for the ! ! , one for " # $ $ and twelve selections
to enable or disable communications from each of the
twelve available scales.
! !
- Turn audio alarm $ $ or .
" # $ $
- Set Cab Control 400 to turn off after % , & or '
minutes.
- Disable or enable each of the twelve scale
selections.
Note: Disable unused scale selections to avoid selecting
scales that are not in use.
Setup Cab Control 400
1. Follow steps “a” and “b” to enter the “SETUP” menu:
a. Turn the unit off.
b. Hold [Net/Grs], press [On] momentarily and
continue to hold [Net/Grs] for 8 seconds.
( )
and ! ! will show on the display followed by the
current setting.
2. Press [Net/Grs] or [Select] to toggle the buzzer or
* *
.
3. Press [On] to save the setting and advance to " # $ $ .
4. Press [Net/Grs] or [Select] to select $ $ , % , & or ' .
5. Press [On] to save the setting and advance to the next
selection.
6. Press [Net/Grs] or [Select] to enable (Y) or disable (N)
each of the twelve available scales.
7. Press [On] to save the setting and advance to the next
selection.
8. After scale number twelve has been set, press [On] to
exit or [Net/Grs] to run self-test.