Echo Bear Cat SC2206 - Manual (Page 14)

2.75 INCH CHIPPER/SHREDDER 10
section
5 sERvIcE & mAINTENANcE
5.1 mAINTENANcE scHEduLE
5.2 cHIppER bLAdE mAINTENANcE
WARNING
the items listed in this service and maintenance schedule are to be checked, and if necessary, corrective action taken.
this schedule is designed for units operating under normal conditions. if the unit is operating in adverse or severe
conditions, it may be necessary for the items to be checked and serviced more frequently.
sEE ENGINE oWNER’s mANuAL FoR FuRTHER ENGINE mAINTENANcE ANd TRoubLEsHooTING
INFoRmATIoN.
the chipping blades are sharp! use care when working
on the machine to avoid injury.
the chipper blades will eventually become dull, making
chipping difficult and adding extra strain on the machine.
cHEcK THE sHARpNEss oF THE bLAdEs EvERY
5 - 15 HouRs oF opERATIoN ANd sHARpEN As
NEEdEd.
your blades need to be sharpened if:
•
Machine vibrates severely when material is fed into the
chipper.
• small diameter branches do not self-feed.
• Chips discharge unevenly or have stringy tails,
especially when chipping green branches.
WARNING
Do not tip the machine all the way over on its side when
servicing.
sERvIcE ANd mAINTENANcE scHEduLE
FREQuENcY
compoNENT
mAINTENANcE
REQuIREd
REFER To ENGINE
opERAToR’s mANuAL
bEFoRE
EAcH usE
EvERY 8
HouRs
air ClEanEr CHECK anD ClEan (1)
EnginE oil CHangE (1)
sParK Plug CHECK ConDition anD gaP
EnginE oil CHECK/Fill
FuEl tanK CHECK/Fill
all intErnal anD ExtErnal
nuts anD bolts
CHECK tigHtnEss
CHiPPEr blaDEs
CHECK sHarPnEss anD rE-
torQuE to 25 Ft-lbs (2)
sHrEDDEr KnivEs CHECK ConDition
EntirE MaCHinE ClEan
(1) PErForM MorE FrEQuEntly unDEr ExtrEMEly Dusty ConDitions.
(2) PErForM MorE FrEQuEntly WHEn CHiPPing Dry or Dirty WooD.
As the Limited Warranty states, failure by the owner to perform normal maintenance will void the machine’s
warranty. The aggressive, high-speed nature of chipping REQuIREs THE oWNER To pERFoRm THE AbovE
LIsTEd NoRmAL mAINTENANcE. special consideration to maintain and re-torque the cHIppER bLAdEs, ANd
ALL INTERNAL ANd ExTERNAL NuTs ANd boLTs is the sole responsibility of the owner. Failure by the owner
to do so shall be cause for denial of warranty.