Use and maintenance instruction and arm adjustment – ENVIROMAC 103 Snorkvac User Manual
Page 12
Drawing 5.
Light kit mounting.
Before mounting the light kit, remove the plug from the side of the hood (for mounting a control switch)
and unscrew the plate at the centre of the hood (for mounting halogen lamp). You need also to remove
the hose from the hood joint (4”, 6” and 8” versions) or take the hood off (3” version).
Do the following after you have completed the above:
− place the wire set (1) moving it through the wire seal (9) inside the light kit dome (11)
− connect the control switch (7) to the wire set (1) and mount the switch on the side of hood (8)
− plug in (connect) the halogen lamp (2) into the wire set socket
−
put halogen lamp (2), o-ring seal (3), protecting glass (4) together and place them inside the hood
−
Install the mounting plate (5) with using the bolts (6).
Use and maintenance instruction and arm adjustment
The installed self-supporting arm should be checked for freedom of movement and rotation of the
socket. If excessive resistance exists at the joints, adjustment must be carried out. It is recommended
to spray the hood (before work, each day) with antispatter preparation. It will make easier cleaning of
the device every day.
The maintenance of the device is carried out periodically as follows:
a) every day
• Clean inner surface of the hood and outer surface of the arm.
• Check self-locking of the arms and the hood, and adjust it if it is necessary.
b) once per month
• Grease the rotating socket with bearing grease which does not react with aluminum.
1
wire set
2
halogen lamp („cold type”) 12VAC/35W
3
o-ring seal
4
protecting glass
5
mounting plate
6
bolts
7
control switch
8
hood
9
wire seal
10 shield
11 light kit dome