ENVIROMAC 103 Snorkvac - Manual (Page 9)

• The flexible hose (7) connecting the elements of the self-supporting arm (“bending” of device) are
attached by means of gear clamps (8).
• The hood (10) is fabricated of aluminum sheet with the handle (9), which facilitates easy placement
of the unit in the required position. The hood is added according to the version and powder coated
with polyestro-epoxide "thermo-hardened" paint.
• The manual damper installed on the arm tube II (4) near the hood.
Wall or ceiling mounted version:
• Mounted via the flange of the outer sleeve (of rotating socket) to the support structure (bracket) by
means of six screws M6 (3/8”).
• To aid the up and down movement of the arm, each 4”, 6” and 8” unit is provided with an
encapsulated spring (11) and fixed to the inner sleeve of the rotating socket and the tube of arm I.
Portable (Bench Mount) version:
• Mounted via the flange of the outer sleeve (of rotating socket) to the support structure by means of
bolts M6 (3/8”).
• To aid the up and down movement of the arm, each 4”, 6” and 8” unit is provided with a cylinder
springs fixed to the inner sleeve of the rotating socket and the tube of arm I. These springs are
placed inside the tube.
• To protect the arm from falling below a certain level, a steel cable is attached parallel to the spring
as above (6” and 8” versions).
Optional hood accessories (special order):
• Inlet Hood Grill to prevent rags and large objects from entering the arm.
• Light Kit with Control Switch for light and/or fan.
Mounting and assembly instruction
Mounting instructions: