ETA Andare Animal - Manual (Page 20)

– Never leave the product unattended when in operation!
– Never immerse the vacuum cleaner into water (even its parts)!
– Never vacuum without a properly inserted filtration system and micro–filters.
– Before you start using the vacuum cleaner, please check that all the blocking mechanisms
are in the right position.
– Do not vacuum wet or moist floor coverings, do not use the vacuum cleaner for outdoor
areas! When moisture gets into the aggregate, there is a risk of its damage and disabling it.
This defect is not covered by the warranty.
– Vacuum cleaning of some carpet types may result in generating static electricity. No static
electricity discharge is dangerous to health.
– Do not vacuum sharp objects (e.g. glass, shatter), hot, flammable, explosive items
(e.g. ash, hot cigarette butts, gasoline, thinners and aerosol vapours) or greases
(e.g. fats, oils), caustic agents (e.g. acids, solvents). Vacuuming these objects may lead to
damage of the dust filters, or the vacuum cleaner.
– Do not insert fingers or other things to input and output vents of the appliance. If the openings/
elements for air flow are clogged (e.g. the hose), turn the appliance off and clear the clogging.
– When handling, do not pull the hose and avoid rough handling of the vacuum cleaner!
– When carrying, do not hold the vacuum cleaner on the handle of the dust container!
– The vacuum cleaner is not suitable for vacuuming substances that can harm human health.
– Pores of the micro filters may be clogged when vacuuming very fine dust. Thus, air
permeability will be reduced and the suction performance will drop. In this case, micro–
filters have to be cleaned before the container is full. Do not use the vacuum cleaner to
vacuum dirt produced during/after construction such as plasterboard dust, fine sand,
cement, dust from construction, parts of plaster etc. If this dirt / loose construction
materials / loose construction materials into the aggregate, it poses a danger of damage.
The warranty repair does not cover this.
– Always switch off the vacuum cleaner first and disconnect the power cord from power supply
and only then empty the dust container, clean/replace micro–filters, clean the vacuum
cleaner or its accessories.
– Never leave the vacuum cleaner exposed to weather conditions ( rain, frost, direct sun
radiation, etc.).
– The power cord is marked with colour codes. The yellow strip indicates the ideal cord length,
the red strip indicates the maximum cord length. Do not apply force to unwind the cord
beyond the red mark.
– Do not run over the power supply cord when using the vacuum cleaner and do not unplug
it from the socket by pulling the power cord.
– When taking the plug from the electric socket, never pull the power cord or the vacuum cleaner.
– When winding the cord, hold the plug to prevent the cord lashing around and to prevent
possible injury.
– If you need to use an extension cord, it has to be uncorrupted and it has to comply with the
valid standards.
– In order to ensure safety and proper function of the appliance, use only original spare parts
and accessories approved by the manufacturer.
– Never use the appliance for any other purpose than for the intended purpose described
in these instructions for use!
For trouble-free operation of the vacuum cleaner, please use the
tested micro-filters recommended by the producer.
GB
20 / 39