ETA Andare Animal - Manual (Page 21)

– The manufacturer is not responsible for damage caused by improper use of the appliance
and the accessories and its guarantee for the appliance does not apply in situations when
the safety warnings above are not complied with. Failure to replace or maintain all filters
regularly according to the instructions in Chapter IV. USING VACUUM CLEANER and
also using non–original filters, the properties of which resulted in failure or damage of the
vacuum cleaner is also understood to be improper use of the appliance.
II EQUIPMENT AND ACCESSORIES OF VACUUM CLEANER ETA – 1493/10 (Fig. 1)
A – vacuum cleaner
A1 – suction vent A7 – power cord
A2 – START/STOP button A8 – holder
A3 – power cord winding button A9 – exhaust filter
A4 – full container indicator A10 – exhaust cover
A5 – electric motor regulation A11 – parking hole
A6 – container lock button
B – dust container
B1 – holder B4 – foam micro–filter
B2 – bottom lock button B5 – HEPA filter
B3 – bottom flap B6 – separator
C – accessories
C1 – floor nozzle C5 – brush
C2 – suction hose C6 – crevice nozzle
C3 – suction tube C7 – accessories holder
C4 – upholstery nozzle C8 – TURBO nozzle
C9 – narrow TURBO nozzle
III. PREPARING THE VACUUM CLEANER
Hose
– Connect hose C2 to the vacuum cleaner by inserting the end piece to suction vent A1 to
the maximum position (Fig. 4). You will hear a clicking sound.
– Disconnect the hose by pressing the button on the end piece and pull the hose out
slightly.
Telescopic tube
– You can connect tube C3 with hose handle C2 by slight pushing the handle to the tube
(Fig. 3).
– You can disconnect the tube by pulling the handle slightly out of the tube.
– The telescopic tube allows setting the suitable length according to your figure. Press the
lock pin in the direction of the arrow and pull out or push in the required length of the tube
(Fig. 5). When you release the lock pin, the tube length is fixed. When pulling out, keep
the tube in the safe distance from your face as the tube is very long.
Floor nozzle / TURBO nozzle / narrow TURBO nozzle
– Connect and disconnect the accessories ( C1, C8, C9) in the same way as the tube
(Fig. 2).
Upholstery/crevice nozzle, joint brush
– Connect and disconnect the accessories ( C4, C6, C5, ) in the same way as the tube
(Fig. 3).
GB
21 / 39