Use and place the iron on a stable surface – ETA Viento User Manual

Page 21

Advertising
background image

Iron and its supply keep out of reach of children under 8 years

(when is plugged in to power or cools down).

Use and place the iron on a stable surface.

When putting the iron on a stand, make sure that the surface that

the stand is placed on is stable.

– After finishing work and before cleaning, always switch off the appliance and disconnect

it from power supply by taking the power cord connector out of the electric socket.

– Whenever you fill the container with water during ironing and empty the container after

ironing, unplug the iron from the electric power.

– The appliance is intended for use in households only and for similar use (in shops,

offices and similar areas, in hotels, motels and other residential areas, in bed and

breakfast facilities)!

It is not designed for commercial use!

Do not use the iron outdoor!

– Do not use the iron as room heating device!

– Do not put any objects to the iron.

– Do not use the appliance with program, time switch or any other item, which switches ON

the appliance automatically, as there is a risk of fire, when the appliance is covered or

improperly located.

– Never iron or steam iron the clothes on persons (directly on body) and do not direct the

steam to any persons or animals.

The thermostat can never be used as a switch!

– Never immerse the appliance into water (even its parts)! Do not wash it under running water!

– Any modification of the appliance surface (e.g. by means of self-adhesive wall-paper, foil

etc.) is prohibited!

– Do not place the iron in such a way that could represent harm (e.g.

fire, burn and scalding).

– Due to production tests, the internal iron container can be misted up. Do not consider it to

be a defect when purchasing the iron.

– Never

pour water to the container that was produced by defrosting of a freezer, water

condensed in a dryer, air-conditioning or dehumidifying units, certain types of mineral

waters, rain-water, water enriched with alcohol, perfume and preparations for treatment

and for stiffening fabrics (e.g.

starch, fabric conditioners) or vinegar, decalcifying

agents, softeners or other chemical substances. Do not use pure distilled water.

– When ironing, be very careful, tilting of the iron may result in the hot water pouring out of

the filling hole.

– Make sure that the power cord is always dry and it is not damaged.

– Regularly check condition of the appliance power cord.

– The power cord must not be damaged with sharp or hot objects, open fire, it must not

be sunk into water or bent over sharp edges. Never put it to hot surfaces, prevent its

free hanging over edge of table or work board. Touching, stumbling or pulling the power

cord e.g. by children may cause tipping over or falling of the appliance with subsequent

severe injury!

– The appliance is portable and it is equipped with a movable connector with a plug which

ensures double-pole disconnection from power supply.

– If you need to use the extension cord, it has to be uncorrupted and it has to comply with

the valid standards.

– Never use the appliance for any other purpose than for that described in these

instructions for use!

21

GB

/ 45

Advertising