ETA Viento - Manual (Page 24)

Sprinkling appliance (additional spray)
It is used for moistening fabrics and it is effective in ironing extremely creased fabrics.
It is activated by repeated pressing of additional spray button E. We do not recommend
applying additional spray for fine fabrics (e.g. silk and synthetic) as the used water may
stain the fabric.
Intensive steaming (steam shock)
Use only if the steam ironing is insufficient. In this case press intensive steaming button
F several times (Fig. 6A - ). Thus you will get additional steam except for the steam
created by standard steaming.
Warning
When you press intensive steaming button F several times, water may drip from the ironing
plate due to excess water in the steam chamber. Do not consider this as faulty operation.
VERTIcAL SYSTEM
It is intensive vertical steaming for steaming of freely hanging textiles (such as hanging
clothes, draperies, hangings). Set the regulation wheel H to the marked area for steaming
(Fig. 2). As soon as the indication lamp G turns OFF, stretch the fabric slightly with one
hand and move the iron vertically bottom-up (Fig. 6B - ). Press the intensive steaming
button F so that you reach vertical steam hammer. Do not hold the intensive steaming
button pressed continuously and do not use it more than 10 times consecutively.
cAUTION
- Prevent burning of sensitive fabrics, do not close them to the iron to distance of 10 to
20 cm.
- Use the VERTICAL function only if the regulation wheel H to the ••• or maximum position.
- Do not iron clothes that you or other people are wearing!
- Never direct steam flow to persons or animals!
DRIP STOP
The appliance prevents leaking water from the ironing plate when its temperature is
insufficient.
Safety electronics (AUTO STOP – applies for type ETA 6284 /00/10/20)
The safety electronics ensures switching OFF the iron plate heating within 30 seconds,
when the iron is left without any movement in horizontal position or when it is tilted over
to one side, or within 10 minutes, when it is left in vertical position. Function of safety
electronics is signalled by flashing of indicator lamp G and by acoustic signal (beep). The
iron is restarted automatically, when the ironing is resumed.
Self-cleaning system (SELF cLEAN)
Hold the iron disconnected from power supply in your hand, turn steaming regulator D
to 0 position (Fig. 5) and lift off cover C to open the filling container lid. Pour water into
container I using the enclosed cup O to fill half of it and close the filling hole lid (Fig. 4) by
snapping it. Keep the position of the iron for pouring water in it. Put the iron to the rest
position (Fig. 7) and set the regulation wheel H to the maximum position. Plug power cord
M into a socket. When the control light G switch off, disconnect the iron from the electric
power. Hold the iron in the horizontal position over a sink. Press the SELF cLEAN button
repeatedly (two to three times), each time for about 5 seconds.
24
GB
/ 45