ETA Viento - Manual (Page 26)

Problem cause Solution
Sprinkling equip-
ment (additional
spray) does not
sprinkle water
There is no water in the container Pour water into the container
The water system is aerated
Tighten finger on the additional spray
jet hole and at the same time press the
sprinkling device button several times
Water is dripping
from the ironing
plate
The lid of the pouring hole of the
container is not closed properly.
Close the pouring hole lid
Low temperature is set Use the regulation wheel to set a
temperature, during which you can use
steaming and wait till the iron is heated
for using it
The steam shock function was
used when temperature below
ooo was set
Use the regulation wheel to set a tem-
perature ••• or MAX
The SELF CLEAN button was
pressed during ironing
Do not use the SELF CLEAN function
After finishing ironing, the iron
was put into the horizontal positi-
on and the steaming regulator is
not in 0 position
Move the steaming regulator to 0 po-
sition, empty the container and put the
iron into the rest position
Flakes and other
impurities are pee-
led off the ironing
plate
Contrary to recommendation undi-
luted water is used with excessive
hardness >15 °N
Use water diluted with distilled water
Clean the iron using the SELF CLEAN
function and steam shock
Brown liquid is
pouring out of the
ironing plate
Improper chemical agents were
used for removing scale
Do not add any chemical agents into
the water container for removing scale
You use one of the types of water
that we do not recommend
Use only common clean drinking water
for filling in the container, or water
diluted with distilled water
Fibers from linen got into the
holes in the ironing plate and they
are burning there
Clean the iron using the SELF CLEAN
function and the steam shock, or va-
cuum the cooled plate delicately from
time to time
The ironing plate
is dirty or it has
brownish colour
High temperature is set Set the program/temperature by the
control that corresponds to the ironed
material so that the material is not
burned on the ironing plate
Laundry is not sufficiently rinsed
and it contains residues of wa-
shing powder, softener or starch
Clean the ironing plate (see Mainte-
nance).
Rinse the laundry properly.
The ironing plate
surface is scratch-
ed
The plate was in contact with
sharp and hard objects while
ironing
During ironing, avoid contact with me-
tal objects containing sharp edges and
do not put the iron on a metal base
with sharp edges and protrusions
26
GB
/ 45