ETA Mezo - Manual (Page 27)

– Do not insert the power plug into the electric power socket and do not pull it out of the electric
power socket with wet hands or by pulling on the power cord!
– Do not connect this appliance to a programmer device, a timer or any other device, which
switches power to the appliance automatically.
– Never leave the appliance unsupervised, unfilled and check it during the whole time of
preparing meals!
– Do not use the appliance for heating of rooms!
– It is not allowed to modify the surface of the appliance in any way (e.g. using
a selfadhesive wallpaper, foils, etc.)!
– Make sure hair and loose pieces of clothing do not get into the attachments or into the
rotating drive to avoid risk of them tangling up in the mixing blade or the rotating drive itself.
– When using the kneading hook, run the drive unit at speed 3 maximum.
– The maximum time of processing is 10 minutes. Then wait for 30 minutes, which is necessary
for the drive unit to cool down.
– Check the condition of the power cord of the appliance regularly.
– Never submerge the appliance under water and do not wash under running water!
– Do not leave the appliance in operation without supervision and supervise it for the entire time
that food is being prepared!
– Use the appliance only in the working position in places, where there is no risk of it being
knocked over and at a suffi cient distance from sources of heat (e.g. fire stoves, electric/gas
stoves, cookers, etc.), and wet surfaces (kitchen sinks, wash basins etc.).
– Before preparation, remove possible packages from food (e.g. paper, a PE bag, etc.).
– Do not turn on the appliance without any ingredients inside!
– Use the appliance only with accessories designed for this model. The use of other accessories
may present a danger for the user.
– Do not insert accessories into any body cavities.
– Never insert your fingers into the filling opening and do not use a fork, knife, spatula, spoon,
etc. Use only the supplied pusher for this purpose.
– Do not exceed the maximum continuous operating time of the appliance, see table!
– The appliance is equipped with safety fuse which disconnects current supply incase of engine
overloading. If it occurs, unplug the appliance and let the appliance getcooled.
– The appliance is also equipped with a mechanical safety. The cog wheel located on the
conveyor screw is designed to, in the case that bones or kitchen utensils get into the meat
mincer, to break and so prevent causing damage to the motor. If such a situation occurs,
follow the instructions in paragraph V. MAINTENANCE.
– Due to safety it is not possible to change the attachments while the drive unit is in operation.
– Allow the rotating parts to fully stop before removing the lid.
– Handle the accessories very carefully, they are very sharp.
– Do not process foods with a temperature over approx. 80 °C (176 °F).
– If the processed foods start to stick to the accessories (e.g. on the blades or steel bowl,
bowl cover), turn off the appliance and carefully clean the accessories (e.g. with a spatula).
– Make sure that the power cord does not come into contact with the rotating part of the
appliance.
– The power cord must not be damaged by sharp or hot objects, by an open fl ame and it must
not be submerged under water.
– Use this appliance only for the purpose for which it was designed as specifi ed in this
user‘s manual. Never use the appliance for any other purpose.
27
GB
/ 54