ETA Tampo - Manual (Page 19)

– The producer does not undertake any responsibility for damage caused by improper use of
the appliance (e.g. deterioration of food, injury, burning, scalding, fire, etc.) and its guarantee
does not cover the appliance in the case of failure to comply with the safety warning above
Caution
Do not use the appliance with a program, time switch or any other part that turns the
appliance on automatically as there is a risk of fire if the appliance is not covered or
placed properly.
!
II. DESCRIPTION OF THE APPLIANCE (Fig. 1)
A1 – hinged lid A6 – power cord
A2 – signaling lights A7 – replaceable plates
A3 – handle A8 – 0/I switch
A4 – lock
A5 – replaceable plates (sandwich / grill / waffle)
III. PREPARATION FOR USE
Remove all the packing material and take out the toaster. Remove all possible adhesion
foils, stick-on labels or paper from the toaster. After the first putting into operation and let
an „open“ toaster in operation with a window open for about 10 minutes, then turn it off and
let it cool down. Possible short-time mild smoke is not a defect and the appliance is not
subject to a complaint for this reason. After the appliance cools down, swipe the parts that
come in contact with food with a soft, wet and clean cloth or a paper towel (see par.
V. MAINTENANCE). Now the appliance is ready for use.
Changing the boards
Press button A7 and remove board A5 by tilting (Picture 2). Insert the protrusions on the
board to the two openings in the coating and secure by tilting (you will hear a click sound)
IV. INSTRUCTIONS FOR USE
Place the toaster on flat and dry surface (e. g. kitchen table) at least 85 cm high, out of
reach of children. To choose the desired replaceable plates take out those which are
placed in the appliance (unless you want to use those). Take them out by pressing the
arrest buttons A7. Then insert the desired replaceable plates into the appliance. Their
proper attachment is signalled by an audible click. Plug the power cord connector A6 to an
electric socket and make sure the power cord is not damaged, it goes under the toaster or
through any sharp or hot surfaces. The electric socket must be easily accessible so that
a toaster can be easily disconnected from power supply if danger appears. Move switch
A1 into position “I”. A red signaling light A2 will come on, signaling connection to electric
power supply. The plates will start to heat. When the operating temperature is reached,
the green signaling light A2 will come ON. When the appliance is used for the first time,
short and slight smoke may occur which does not mean any defect. Open the lock A4 and
lift off the lid A1 using the handle A3. Put the prepared food on the bottom plate A5, close
the lid and secure it with the lock A4. Do not close the lid by excessive force! During
preparation of food, the green signaling light will come on and off which means that the
thermostat keeps the proper temperature.
19
GB
/ 37