ETA Fricool - Manual (Page 23)

III. INSTRUCTIONS FOR USE
Remove all packing material and take out the deep fryer with the accessories. Remove all
possible adhesion foils, stick-on labels or paper.
Before the first use, wash the parts that will be in contact with food in hot water with
detergent, rinse thoroughly with clean water and wipe till dry, or let dry.
Assembling the individual parts (pic. 2, 3, 4, 5, 6)
– Insert the frying pot B into the body A.
– Control panel D with the heating element D1 insert into the pot B so that the guiding
edges D2 on the control panel slide into the guiding grooves A1 on the body A (an
audible click will be heard). If the control panel with the heating element is not correctly
attached (inserted), the safety switch D8 will prevent the deep fryer from operating.
– Attach the handle C1 to the frying basket C by gently pushing the wires towards each
other using your fi ngers and sliding the wires into the metal holders and then insert the
bent out ends into the holder openings in the basket. Subsequently with gentle pressure
secure the holder in place in the locked position (an audible click will be heard).
– Place the lid E on to the pot B so that the filter E3 is facing the control panel.
Following the reverse order you may again disassemble/remove all the parts (or if
required assemble them).
2 3
A
b
C
d
4
5 6
Over-heating protection
The fryer is equipped with a safety heat switch which will disconnect the heating body in
case of insufficient or no amount of oil.
23
GB
/ 48