ETA Svářečka fólií Freshie - Manual (Page 23)

23 / 49
GB
22
– Keep it away from sources of heat, direct sunlight, humidity (never dip it into any liquid) and
sharp edges. Do not use the appliance with wet hands. If the appliance is humid or wet, unplug
it immediately, let the appliance dry thoroughly a have it checked by a professional before next
use. Do not put it in water.
– It’s better not to use an extension cord with this unit. However, if one is used, it must have
a rating equal to or exceeding the fating of this appliance.
– Do not try to repair the appliance on your own. Always contact an authorized technician.
To avoid the exposure to danger, always have a faulty cable be replaced only by the
manufacturer, by our customer service or by a qualified person and with a cable of the same type.
– Use this appliance only for its intended purpose described in these instructions for use! Never
use the appliance for any other purpose!
– Use only genuine accessories. If you use other accessories, it may be dangerous.
– Pay careful attention to the following “Special Safety Instructions for this unit“.
SPEcIal SafETy INSTRUcTIONS fOR ThIS UNIT
– Make sure the power supply meets the voltage marked on the label before power on the
appliance.
– The power cord plug has to be connected to the properly connected and grounded socket
according.
– Do not leave appliance when plugged in. Unplug from outlet when not in use.
– Do not vacuum seal liquids
– Do not do the following: pull or carry by the cord, use cord as a handle, or pull cord around sharp
edges or corners. Do not operate appliance over cord. Keep cord away from heated surface.
– Do not use the appliance with a programmer, time switch or any other device that turns the
appliance on automatically because there is a danger of fire, if the appliance is covered or
improperly placed.
– It is not acceptable to adjust the surface of the appliance in any way (e.g. sticker wallpaper,
foil, etc.)!
– When handling the appliance, be careful not to induce injuries (e.g. burning).
– The air openings must not be covered. Do not push or throw any objects into the openings.
– Do not plug or unplug the power cord fork with wet hands or by pulling at the cord.
– When it In “ON” or working position, always be on a stable surface, such as table or counter.
– It’s no need to use any lubricant, such as lubricating oils or water, on this appliance.
– Do not handle plug or appliance with wet hands.
– WaRNING: Appliance not far continuous use. Approved for one operating cycle per 2 minutes.
– The appliance has a hot surface. Persons insensitive to heat must be careful when using the
appliance.
– Do not vacuum air when sealing liquids in bags.
– If the electric welder was stored in lower temperatures, leave it in room temperature whih will
help keep the mechanical firmness of the parts.
– Prevent any liquid from getting into the nozzle of the exhauster!
– Never immerse the welder in water and do not wash in running water!
– The appliance is not designed for constant operation. Do not use the welder constantly for
longer than 15 minutes, then leave it to cool down for approx. 30 minutes.
– The manufacturer is not responsible for damages caused by misuse of the appliance
(e.g. degraded food, injury, burning, fire) and is not liable under the warranty for the appliance
in case of violating the above-mentioned safety cautions.
– Always turn the appliance off and disconnect it from power source by unplugging the power
cord fork from the plug after finishing work.
– After completion of the vacuum process leave the cover of the appliance open for the welding
part to cool down.
WARNING: HOT SURFACE