Flowserve Byron Jackson Type M - Manual (Page 35)

® Byron Jackson Double Mechanical Seal Submersible Pumping Unit • 1042.293/9 • June 04
Page 35 of 68
4.4.11 Install power cable
NOTE Not all components or sub-
assemblies of a pumping unit are
necessarily supplied by Flowserve
or part of this delivery.
These user instructions apply only
to the components or sub-
assemblies supplied by Flowserve
in this delivery, see Chapter 12.1
"Scope of delivery".
•
Use a rope to hold the cable and the power
cable installation wheel to support the power
cable.
•
Bring the power cable looping up off the
power cable reel stand so that the power ca-
ble terminal box is suspended over the power
terminal shipping cap.
CAUTION Do not strain the power cable or
bend it sharper than a diameter of
14 times the power cable outer di-
ameter.
Avoid strain on terminal box.
Do not use cable installation wheel
to suspend cable above the top of
pump bowl assembly until the flat
cable guards are securely banded.
In the following, two variants of the power cable
are described:
•
Power cable for voltages of 2 300 V and less
(metal clamp power terminal connector)
•
Power cable for voltages of 4 000 V and
greater (metal housing power terminal con-
nector)