Flowserve SoftTools Suite 7.0 - Manual (Page 20)

VLAUG001-00 ©Flowserve Corporation, Valtek Control Products, Tel. USA 801 489 8611 20 of 21
6. From the device selection list, expand the Ports item.
10. Right click the communication port you desire to use with SoftTools.
NOTE: USB adapter cables and modems will have their own COM ports
assigned when the driver(s) are installed. This installation typically occurs the
first time the adapter or modem is connected, and the drivers are installed
using the manufacturer’s installation software (typically on a CD). This is not
usually COM Ports 1 or 2. Care must be taken to ensure that the correct COM
port is selected, or the FIFO buffers will be disabled for the incorrect COM Port.
11. Click Properties.