Dolby Laboratories DP569 - Manual (Page 9)

Model DP569 User’s Manual
ix
Regulatory Notices and Fuse Information
FCC
This equipment has been tested and found to comply with the limits for a Class A digital device,
pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection
against harmful interference when the equipment is operated in a commercial environment. This
equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in
accordance with this instruction manual, may cause harmful interference to radio communications.
Operation of this equipment in a residential area is likely to cause harmful interference in which
case the user will be required to correct the interference at his or her own expense.
Canada
This Class A digital apparatus complies with Canadian ICES-003.
UL
WARNING:
Troubleshooting must be performed by a trained technician. Do not attempt
to service this equipment unless you are qualified to do so.
Check that the correct fuses have been installed. To reduce the risk of fire,
replace only with fuses of the same type and rating.
Exposed portions of the power supply assembly are electrically "hot". In order to reduce the risk
of electrical shock, the power cord MUST be disconnected when the power supply assembly is
removed.
The ground terminal of the power plug is connected directly to
the chassis of the unit. For continued protection against
electric shock, a correctly wired and grounded (earthed) three-
pin power outlet must be used. Do not use a ground-lifting
adapter and never cut the ground pin on the three-prong plug.
UK
The power cord Dolby part 92021 supplied for use in Europe is not suitable for use in the UK. To use
the cord in the UK cut off the CEE7/7 plug and replace with an approved BS 1363 13A plug:
• The core that is coloured green and yellow must be connected to the terminal in the plug
identified by the letter E or by the earth symbol or coloured green or green and yellow.
• The core that is coloured blue must be connected to the terminal that is marked with the letter
N or coloured black.
• The core that is coloured brown must be connected to the terminal that is marked with the
letter L or coloured red.
• This apparatus must be earthed.