Controller level electrode, Annex – Flowserve NRR 2-40 User Manual
Page 28
Advertising
28
Fig. 13
The node IDs of the individual units have to be adjusted manually.
For more information refer to the corresponding installations manuals.
Controller
Level electrode
If several systems of the same kind are to communicate in one CAN bus network, be
sure to assign one node ID for each individual system component (e. g. controller).
Detach terminal strip in order to set code switch .
Assigning / changing node ID
Annex
Factory set default node IDs
Attention
■
Do not assign the same node ID twice within the CAN bus network.
Ther terminal strip of the NRR 2-40 is live during operation. This presents
the danger of electric shock.
Cut off power supply before fixing or removing the housing lid or the
terminal strips.
Warning
8
A
Advertising