Annex, 250 kbit/s – Flowserve NRR 2-40 User Manual
Page 31
Advertising
31
Annex
– continued –
Adjust neutral band according to fig. 18.
■
Neutral band in this example “2 %”
Status LEDs flash rapidly
Apply mains voltage.
The four status LEDs flash rapidly. If the
LED “Power” is alight, the adjustment
was successful.
If the LED (“Bus status”) above the LED
“Power” is alight, repeat the adjustment
procedure.
LED “Power” illuminated
Status LEDs flash rapidly
Apply mains voltage.
The four status LEDs flash rapidly.
The LED “Power” is illuminated.
The system is ready for operation.
LED “Power” illuminated
Switch off mains voltage.
The four status LEDs go out.
The LED “Power” goes out.
LED “Power” extinguished
Adjust current node ID and baud rate.
■
Node ID in this example “40”
■
Baud rate in this example
“
250 kBit/s”
Advertising