Dometic RM2852 - Manual (Page 10)

- 10 -
Snap in
To mount the panel, follow these steps:
Open the door 90 degrees.
On new refrigerators,
the decoration strip are
taped inside the door;
if installed on the door,
remove the door decora-
tion strip (2) by gently
pushing the four tabs
away with a fl at blade
screwdriver (1).
Insert the vertical edges
into the grooves of the
door frame (3).
Push the panel down-
wards so that the lower
horizontal edge of the
panel (4) is fi tted into
the bottom grove (5).
Snap in the decoration
strip (2).
1.
2.
3.
4.
5.
RM2351-2354
We recommend to mount the panel on the door before the
refrigerator is installed in the enclosure.
To mount the panel, follow these steps:
Slide the panel from the bottom of the door into the
grooves on the vertical edges of the door .
Push the panel upwards.
Put the two plastic panel stops (from the parts bag)
in the two holes at the lower door frame.
Put the decoration strip across the door and fasten it
with three screws (from the parts bag).
RM2451-2454-2551-2554-2652-2662- 2663-2852-
2862 & NDR1062
With screws
To mount the panel, follow these steps:
Open the door 90 de-
grees.
On new refrigerators,
the decoration strip is
taped inside the door; if
installed on the door, re-
move the door decoration
strip (2) by removing its
three screws (1).
Insert the vertical edges
into the grooves of the
door frame (3).
Push the panel down-
wards so that the lower
horizontal edge of the
panel (4) is fi tted into the
bottom grove (5).
Put the decoration strip
across the door so that
the gap is covered. Se-
cure the decoration strip
with the three screws
removed in step 2.
1.
2.
3.
4.
1.
2.
3.
4.
5.
MOUNTING INSTRUCTIONS
1
1
1
2
1
1
1
3
3
4
5
1
2
2
To remove the refrigerator, follow these steps:
Cap the gas supply line.
Loosen the screws anchoring the refrigerator to the
enclosure.
Slide the refrigerator out of the compartment.
Replacement is the reverse of removal. When reinstalling the
refrigerator, make sure the sealing strips are properly posi-
tioned. Check all connections for gas leaks.
1.
2.
3.
Before removing the refrigerator:
Verify that the AC and DC voltage leads are disconnected.
Shut off the gas supply.
Disconnect the gas supply line at the rear of the refrigerator.
Always use a back up wrench when loosening and tighten-
ing connections.
•
•
•
REFRIGERATOR REMOVAL