Installation instructions, Drain water hose, Connections gas connection – Dometic RM2852 User Manual

Page 7: Warning

Advertising
background image

- 7 -

INSTALLATION INSTRUCTIONS

Secure the refrigerator and the lower front strip

with two screws: One screw through the hinge

and on the opposite side and then, one screw

through the lower front strip.

Two screws installed in the top frame.

Remove the top decoration panel.
Open the door.

Gently push the tabs out

of the hole in the hinge

with a fl at blade screw-

driver (both sides).
Carefully tilt the top

decoration panel and

lift to remove from top

frame. Be careful not to

damage the circuit board and wires.
Install the two screws in the top frame, the holes

are accessible from underneath.
Seal the opening for the screws with aluminum

tape.
Replace the top decoration panel. Be careful not

to pinch the wires behind the panel. Make sure

the tabs snap back into the holes in the hinge

plate.

Two screws installed in the rear base.

b)

2.

a)
b)

c)

d)

e)

f)

3.

2

1

DRAIN WATER HOSE

A hole must be drilled through fl ooring and the installer needs

to make sure the hose does not kink when run through the fl oor.

Seal around the hose that goes through the drilled hole. If a

longer hose than supplied is required to get the water to drain

outside of the vehicle, the installer will have to supply the extra

length of hose.

CONNECTIONS
Gas connection

Hook up to the gas supply line is accomplished at the manual

gas valve, which is furnished with a 3/8” SAE (UNF 5/8” -18)

male fl are connection. All completed connections should be ex-

amined for leaks using a solution of liquid detergent and water.

Be very careful when working on or near the gas sys-

tem. Do not use an open fl ame to check for gas leaks!

The gas supply system must incorporate a pressure regulator

to maintain a supply pressure of not more than 11 inches water

column. When testing the gas supply system at test pressures:

> 1/2 psi - the refrigerator and its individual shutoff valve

must be disconnected from the gas supply piping system.
≤ 1/2 psi - the appliance must be isolated from the gas

supply piping system by closing its individual manual shut-

off valve.

If detailed instructions on the installation and connection to

the gas supply are required, please contact your dealer or

distributor.

WARNING

!

Hole for drain water hose

RM2351-2354

Hole for drain water hose

RM2451-2454-2551-2554-

2652-2662-2663-2852-

2862-3862 & NDR1062

Advertising
This manual is related to the following products: