GAI-Tronics 234 Stanchion Assembly - Manual (Page 11)

Pub. 42004-194M
234 Stanchion Assembly and Model 234SBA Stanchion Broadcast Assembly Page 11 of 11
f:\standard ioms - current release\42004 instr. manuals\42004-194m.doc
11/12
Repairing Surface Damage to Powder-Coated Stanchions
Scratch Repair
1. Carefully sand the damaged area to clean and score the base metal, taking care to minimize any
additional damage to the surrounding powder coating.
2. Wipe the sanded area with a cleaning solvent, such as DuPont “PrepSol.” Allow the area to dry. This
type of product is available at auto parts stores. Denatured alcohol may also be used.
3. Prepare the bare metal surface for painting by treating it with phosphoric acid solution intended for
this purpose. Allow the area to dry.
4. Using a cotton swap or small brush, paint the prepared surface with an automotive enamel or oil base
polyurethane enamel such as Red Devil or Rustoleum. DO NOT USE Krylon-type paints. Carefully
blend the repair enamel into the powder coat at the edges.
N OTE : EXACT color matches may not be attainable.
Decal Repair
1. Use a sharp instrument, such as an X-Acto knife, to loosen and lift a corner edge of the damaged
decal.
2. Carefully peel back and remove the loosened decal.
3. Wipe the area clean with denatured alcohol. Allow the area to dry.
4. Prior to attaching a new decal, dampen the target area with a fine mist of water (fine spray from a
plant misting bottle is ideal).
5. Peel the backing from the replacement decal, leaving the decal attached to the front cover material,
and carefully align it with the target area.
6. With the cover material still attached, press the replacement decal in place, then squeegee any water
from under the new decal starting at the center and working toward the edges.
7. Peel off the cover material, being careful not to tear or lift the decal. If the decal lifts as the cover
material is being removed, push down on the uncovered decal, and squeegee as necessary to remove
any large bubbles; small bubbles will disappear as the decal dries.
Specifications
Dimensions ................................................................. 10 W  10 D  114 H inches (0.25  0.25  2.89 m)
Wall thickness ...................................................................................................... 3/16-inch cold-rolled steel
Finish ..................................................................................................................................... Powder-coated
Power rating
Model 84503-301 AC Panel Light Assembly .................................................. 25 mA @ 120–230 V ac
Model 84503-302 DC Panel Light Assembly ....................................................... 40 mA @10–33 V dc
Approvals
UL/cUL listed OUTDOOR telephone stanchion ........... Canadian Electrical Code, Part I (CE Code, Part I),
and the ANSI/NFPA 70 National Electrical Code (NEC)